Category Archives: Father’s Day

Happy Vintage Father’s Day


This Father’s Day card was made using only one vintage car stamp, which has been repeatedly stamped and one sentiment stamp…

vintage car

I stamped and cut out one vintage car and adhered using dimensionals and did the same with the sentiment.

To add a little bling, I placed a rhinestone to the centre of each wheel.

Thank you for stopping by

Deborah x


Father’s Day Gift Set


The gift set I have to share with you today is for Father’s Day…

grunge & clockworks Fathers Day 1

It is ideal for the man who has everything, a gift card holder… 

Fathers Day gift card

Just slip off the belly band to open.

Fathers Day gift card 2

For the measurements and instructions for the gift card holder please click here

(the only change I made was to use the envelope punch board to make the opening where the gift card is held)

Thank you for stopping by

Deborah x

Pack of Shirts


The cards I have to share with you today are 3 shirt and tie cards…

shirt & tie - blue

I made 3 different colour combinations

shirt & tie - black

to suit 3 different men.

shirt & tie - grey

These are great cards for both birthday or Father’s Day.

I have been asked for the instructions to make this card, so I thought it would be easier to show you my template –


Conversion table 

3.5cm = 1 3/8″    21cm = 8″    7.5cm = 2 7/8″    10.5cm = 3 3/8″    2cm = 6/8″         

12cm =  4 6/8″     6cm = 2 3/8″     9.5cm = 3 6/8″     4.5cm = 1 6/8″     5cm = 2″       

I covered the front of my card (A4 folded in half) in patterned paper, leaving only a small border, so you could see the coloured card.

Then using the template above, I cut out a collar (the measurement to the point of the collar is 6cm – I missed it off!) and the pocket in the same paper.

The tie, knot and top of pocket are cut out of card stock and I sponged around them all in the same colour ink.

I glued down the tie. The knot was glued at the top, but I used a dimensional at the base, to give it some lift.

The collar was adhered using dimensionals, but used a glue dot were the collar overlaps the knot.

The top of the pocket is glued onto the patterned paper pocket and then adhered with dimensionals.

To finish I added a button and tie pin with my sentiment on.

Thank you for stopping by

Deborah x

Up up and away


The card I have to share with you today is a masculine card …

up up and away

This masculine card can be used as a birthday, thank you or Fathers Day card.

I sectioned off a panel and sponged the grass hills and blue sky, by making a hand cut template, to use as a mask.

The sentiment is from the create a cupcake stamp set!

Here’s what I used:

Stamps: create a cupcake & up,up and away.

Card/Paper: whisper white, elegant eggplant.  

Ink: wild wasabi, elegant eggplant, marina mist & basic grey. 

Punches: modern label, word window & corner punch.

Accessories: dimensionals.

Thank you for stopping by

Debs x

Speed Framed


The card I have to share with you today is a masculine one…

blue sports car

By changing the sentiment, you could make it into a Father’s Day card.

Here is a larger card in red…

large red framed car

Here’s what I used:

Stamps: need for speed & curly cute.

Card/Paper: whisper white, basic black, island indigo & pocketful of posies dsp

Ink: island indigo & basic black.

Punches: small star

Accessories: embossing designer frames, rhinestones, crystal effects, blender pen & embossing folder.

Thank you for stopping by

Debs x