This gift card holder is great for any occasion, just by the choice of paper you use will change the look of the gift card holder… ..
Here are the measurements…
Navy card 10″x4 1/4″ which is scored at 3″ – 4″ – 5″ and 8″
To decorate you will need 4 rectangles 2 3/4″ x 4″ and
2 rectangles 1 3/4″ x 4″ of patterned paper.
I used the envelope punch board to make the opening where the gift card is held.
I did this by placing the left hand side of the navy card up to the letter ‘E’ in the word guide on the punch board and then punching. Then flipped the card over and did the same again. With a pair of scissors or a paper trimmer cut out the bit in the middle, between the two punched out areas.
You can also use the word window punch too, if you find that easier.
Belly band mesurements – Navy card 7″ x 1″ which is scored at 2″ and 5″
To decorate I used the curly label, petite curly label and 1″ square punch.
Thank you for stopping by