Monthly Archives: May 2014

Wedding Acceptance

Standard

The card I have to share with you today is a Wedding Acceptance…

wedding acceptance

This card was inspired by a birthday card I received from my friend Gill.

Thank you for stopping by

Deborah x

Advertisements

Father’s Day Gift Set

Standard

The gift set I have to share with you today is for Father’s Day…

grunge & clockworks Fathers Day 1

It is ideal for the man who has everything, a gift card holder… 

Fathers Day gift card

Just slip off the belly band to open.

Fathers Day gift card 2

For the measurements and instructions for the gift card holder please click here

(the only change I made was to use the envelope punch board to make the opening where the gift card is held)

Thank you for stopping by

Deborah x

Pack of Shirts

Standard

The cards I have to share with you today are 3 shirt and tie cards…

shirt & tie - blue

I made 3 different colour combinations

shirt & tie - black

to suit 3 different men.

shirt & tie - grey

These are great cards for both birthday or Father’s Day.

I have been asked for the instructions to make this card, so I thought it would be easier to show you my template –

DSCN4516

Conversion table 

3.5cm = 1 3/8″    21cm = 8″    7.5cm = 2 7/8″    10.5cm = 3 3/8″    2cm = 6/8″         

12cm =  4 6/8″     6cm = 2 3/8″     9.5cm = 3 6/8″     4.5cm = 1 6/8″     5cm = 2″       

I covered the front of my card (A4 folded in half) in patterned paper, leaving only a small border, so you could see the coloured card.

Then using the template above, I cut out a collar (the measurement to the point of the collar is 6cm – I missed it off!) and the pocket in the same paper.

The tie, knot and top of pocket are cut out of card stock and I sponged around them all in the same colour ink.

I glued down the tie. The knot was glued at the top, but I used a dimensional at the base, to give it some lift.

The collar was adhered using dimensionals, but used a glue dot were the collar overlaps the knot.

The top of the pocket is glued onto the patterned paper pocket and then adhered with dimensionals.

To finish I added a button and tie pin with my sentiment on.

Thank you for stopping by

Deborah x